Installation Guide

AirHarmony-4200 DC (Internal Filters) Installation Guide
UGD-D01196 Airspan Commercial and Internal Use 27
4.2 Pole/Wall Mount Assembly
Install the AirHarmony-4200 DC eNodeB by pole/wall mount. AirHarmony-4200 DC is mounted on a
pole or wall in close proximity to its external antenna (connectorized variant).
Caution: Proper local rigging and hoisting practices should be followed when installing
the AirHarmony-4200 DC.
Mounting on a Pole
The following images show the pole mount assembly on a pole.
Caution: Take care to install the Pole/Wall mounting plate in the correct orientation.
Verify that the mounting pins are facing upwards as shown below.
Figure 7: Pole/Wall mounting plate (w/o bolt)
1. Select the location on the pole to mount the AirHarmony-4200 DC. You can attach the
AirHarmony-4200 DC to any pole from 1-7/8 to 16 inches (47.6 to 406.4 mm) in
diameter.
2. Insert the clamp straps (supplied) through the slots in the mounting plate passing them
through the pole clamps.
3. Insert the clamp bands by passing them through the slots in the mounting plate, in four
(4) places.
4. Tighten the clamp bands with large flat screwdriver.