Installation Guide

AirHarmony-4200 DC (Internal Filters) Installation Guide
UGD-D01196 Airspan Commercial and Internal Use 12
Antenna System
AirHarmony-4200 DC comes in a range of frequency variants that can be mounted with different
antenna options and formats. A typical installation will have a cross-polar sector or dual slant
antenna connected to the approprate RF port of the AirHarmony-4200 DC variant unit. Various
antennas are designed specifically for AirHarmony-4200 DC deployments; specifications are available
from Airspan separately.
External Antenna
The externally mounted antennas should be a dual slant or cross polarized fixed antennas which is
connected via DIN connectors located on the AirHarmony-4200 DC unit. The antennas should be
mounted to its appropriate mounting facility.
AirHarmony-4200 DC, can also support SBA configuration which can be mounted directly to the unit
or remotely. The current permitted antenna type is as specified below:
Table 4: AW3089 Omni Antenna
Frequency Range (MHz)
Antenna Gain (dBi)
Type
3300MHz – 3800MHz
9.5
Dual Port, Omni, +/-45⁰Polarisation, Fixed Tilt
Note: For a list of compatible external antennas, please contact your nearest Airspan Sales
representative.
Figure 1: AirHarmony-4200 DC Internal Filters