User Manual

AS4000 Survey Tool
605-0000-429
Issue 1.6. Date 1/9/99
Appendix F
Page 1 of 1
RF PROGRAMMING CODES
This procedure should be used if programming the system using a test telephone and can
only be applied to Voice STs.
The table below shows the Part numbers and the Rev Level at which revised programming
(3 Digit RF Code) was introduced.
Product Part Number Revised programming
introduced at the following
Rev Level (3 Digit RF Code)
ST-V2 605-0000-411 Rev B
ST-V2 503-0700-144 Rev A
ST-V2 503-0700-149 Rev A
ST-V2 503-0700-134 Rev B
ST-V2 503-0700-129 Rev C
ST-V2 503-0700-136 Rev C
ST-D128 605-0000-536 Rev A
ST-D128 605-0000-538 Rev A
ST-D128 605-0000-334 Rev B
ST-D128 503-0700-127 Rev H
ST-D128 503-0700-140 Rev A
ST-I1 503-0700-141 Rev B
ST-I1 503-0700-128 Rev F
ST-I1 503-0700-139 Rev B
+ All CRUs in the 1.8-1.9Ghz Band
Note: Any other CRU part number or CRUs in the above list with a lower Rev level
should be programmed using the two digit RF Code.
The following table shows the codes used in the RF digit positions when programming
external Fixed Assignment CRUs.
RF #
2/3 digits
PN
1 digit
RW
2 digits
Identity
6 digits
Check N
o
.
1 digit
Remote site
location
1 0 5 1 0 1 * or 000000 7 CRU1
The codes differ depending on the generation of CRU used. Previous release CRUs use a 2
digit code shown in column 3 of the table below. Current release CRUs use a 3 digit code as
shown in column 2 in the table below.