User Manual

AS4000 Survey Tool
605-0000-429
DLP- 006
Issue 1.6. Date 1/9/99
Page 2 of 4
10. When the sections are fully lowered re- tighten the air release screw.
11. Remove all guys from the Guy Collar and safely stow away.
12. When the mast is fully lowered remove the telescopic mast by unscrewing the mast mounting
screw. (replace the screw back into the threaded holes for safekeeping.
13. Disconnect the drop cable at the Headload. Feed the slack drop cable back into the dispenser.
14. Remove the measuring tape and feed slack measuring tape back into the tape reel.
15. Remove the head end load by releasing the quick clamp and extracting the spigot from the
end of the mast of the mast.
16. Unlock the wheels by raising the locking mechanism on each wheel and manoeuvre the
tripod base to a suitable position for folding.
17. Loosen foot locking screw
18. Remove leg locking pin and rotate leg to the tripod body. Release gravity locking detent and
turn the foot parallel to the body of the mast.
19. Slide the foot into leg retainer and re-tighten the foot locking screw.
20. Repeat for the other legs.
Legs
Main Body
Foot
Retainers to
lock legs into
main Body
Locking Pins
Gravity
Locking
Detent
Gravity
Locking
Plate
Foot Locking
Screw
Foot
Swivel
Leg
Swivel
Locking
Wheels
Figure 19 Folded Mast Base
21. Place tripod in carrying bag.
22. Remove all safety barriers and clear the site of any debris.
STOP. THIS PROCEDURE HAS BEEN COMPLETED.