User Manual

AS4000 Subscriber Terminal
Installation and Commissioning DLP 013
605-0000-436
Issue 1.5 Date: 18th October 1999
Page 9 of 14
STMON panel
Comms status Indicates com port to which STMON is attached and status, OK or
Timed out.
Log file size Indicates size of log file size in Bytes, or Disabled if log file option was
not invoked.
Table 22. STMON Panel
ST build status panel
CRU
channel code
Indicates channel code entered during installation - this information
is updated on ST initialisation.
ST Options
Indicates the special options chosen. i.e. the SPM frequency at
12 kHz or 16kHz
ST s/w ver
Indicates the version number of the ST software build - this
information is updated on ST initialisation.
Serial
Number
Indicates size the serial number of the CRU - this information is
updated on ST initialisation.
Identifier
Normally set to 000000
Table 23. ST Build Status Panel
ST s/w
state
number
State name Description
0
Start-up ST is initialising - this should last no longer than 5 seconds
4
Waiting for link ST is functional but has yet to acquire Downlink and Uplink
5
Operative ST is operating correctly
6
Disabled ST has failed authentication and has been disabled by the CT
7
Waiting for off-
hook
ST install mode entered. Not Valid for ISDN / D128
8
Collecting digits Telephone is off-hook and install digits are being collected
Invalid for ISDN / D128
9
Install done ST installation is complete, ST needs to re-boot
10
ST not installed ST has no installation data, no link will be acquired
11
Collecting
STMON Digits
ST is accepting digits from STMON
12
STMON install
Failed
ST did not accept the programming code
13
STMON install
OK
ST has accepted programming code, ST needs to re-boot
Table 24. ST States