User Manual

AS4000 Subscriber Terminal

Installation and Commissioning DLP 006

605-0000-436

Issue 1.5 Date: 18th October 1999

Page 3 of 4

2. Fit the cover to the PSU without securing the screw until instructed to by the

Commissioning Test Procedure.

PSU earthing

1. Note: The Type-4 PSU is double insulated. It still has a 3-pin IEC socket and

therefore uses a 3-wire cable and mains plug. There is no earth wire connected to

the IEC socket inside the unit.

PSU Labelling

If the CRU has been provided with a customer specific logo label, stick the label in

the bottom right hand corner of the front of the case as shown.

10mm

Figure 17. Customer Logo Placement

STOP. THIS PROCEDURE HAS BEEN COMPLETED