User Manual

AS4000 Subscriber Terminal
Installation and Commissioning DLP 003
605-0000-436
Issue 1.5 Date: 18th October 1999
Page 2 of 2
STEP PROCEDURE
AC Power Cord Installation
1. Use a supply cord fitted with a mains plug in accordance with local requirements.
2. Plug the AC supply cord into the IEC connector on the PSU (Type 1).
3. Do not connect the plug to the supply socket until instructed to by the
Commissioning Test Procedure.
Notes:
1. The AC PSU (TYPE 1) is double insulated. It still has a 3-pin IEC socket and
therefore uses a 3-wire cable and mains plug. There is no earth wire connected to
the IEC socket inside the unit.
STOP. THIS PROCEDURE HAS BEEN COMPLETED.
Safety:
Do not allow anything to rest on the power cord and do not locate the
product where persons could step or walk on the power cord.