User Manual

AS4000 Subscriber Terminal

Installation and Commissioning GSI 001

605-0000-436

Issue 1.5 Date: 18th October 1999

Page 1 of 2 1988 Airspan Communications Corporation

INTRODUCTION

1. General

1.01 This document describes the installation and commissioning of the ACC

Communications AS4000 Subscriber Terminals (ST) Equipment to release 3.0

specifications.

1.02 Prerequisite skills. Personnel installing and commissioning the AS4000 STs require

a basic knowledge of telephony and radio communications, and experience in

installing telecommunications products. ACC provides a range of comprehensive

training courses specifically aimed at providing operators/users of AS4000 STs with

the prerequisite skills to install, commission and or maintain the product. The

courses can be tailored to provide the level of training required by the operator/user.

1.03 Intended Audience. This manual is intended for use by persons familiar with the

AS4000 ST having attended the ACC ST Installation and Commissioning training

course.

2. Safety

2.01 Personnel installing the ACC AS4000 product should follow local safety

procedures, particularly those requirements relating to working above ground.

ACC safety procedures are contained in document W300 0002 001 Rev A.

2.02 No hazardous RF radiation is emitted from the equipment. Measured at the surface

of the CRU radome, when transmitting, the maximum total power radiated from the

CRU is 0.01% of the UK National Radiological Protection Board basic restriction

per kg. of body part. Also at the surface of the CRU radome, the power flux density

is approximately one tenth of the investigation level of the UK National Radiological

Protection Board.

WARNING - HAZARDOUS VOLTAGES

On AC installations, hazardous voltages exist. Use caution when verifying or

working with AC power. Remove metal jewellery that could come into contact

with AC power.

On DC sections, short circuiting the low voltage, low impedance circuits can cause

severe arcing that may result in burns or eye damage. Remove rings, watches etc. to

avoid shorting DC circuits.