User Manual

AS4000 Subscriber Terminal
Installation and Commissioning DLP 015
605-0000-436
Issue 1.5 Date: 18th October 1999
Page 1 of 4 1988 Airspan Communications Corporation
PROGRAMMING THE ST-V2 CRU (TYPE 2 PSU AND
TYPE 4 PSU) USING A TEST TELEPHONE
The following procedure will have to be completed before placing the AS4000
Subscriber Terminal into service. This procedure should be used if programming
the system using a test telephone and can only be applied to Voice STs..
Alternatively the system can be programmed using STMON (see DLP-0011/12 .
All results must be entered on the Commissioning Test Result Sheet, see DLP-
019.
The table below shows the Part numbers and the Rev Level at which revised
programming (3 Digit RF Code) was introduced.
Product Part Number Revised programming
introduced at the following
Rev Level (3 Digit RF Code)
ST-V2 605-0000-411 Rev B
ST-V2 503-0700-144 Rev A
ST-V2 503-0700-149 Rev A
ST-V2 503-0700-134 Rev B
ST-V2 503-0700-129 Rev C
ST-V2 503-0700-136 Rev C
ST-D128 605-0000-536 Rev A
ST-D128 605-0000-538 Rev A
ST-D128 605-0000-334 Rev B
ST-D128 503-0700-127 Rev H
ST-D128 503-0700-140 Rev A
ST-I1 503-0700-141 Rev B
ST-I1 503-0700-128 Rev F
ST-I1 503-0700-139 Rev B
+ All CRUs in the 1.8-1.9Ghz Band
Note: Any other CRU part number or CRUs in the above list with a lower Rev
level should be programmed using the two digit RF Code.
STEP PROCEDURE
ST Programming
1. Ensure that the mounted CRU is facing in the general direction of the
CT office before commencing set-up and commissioning procedure.
2. Remove the cover from the PSU