User Manual

AS4000 Subscriber Terminal
Installation and Commissioning DLP 014
605-0000-436
Issue 1.5 Date: 18th October 1999
Page 1 of 4 1988 Airspan Communications Corporation
PROGRAMMING THE CRU USING STMON
The following procedure will have to be completed before placing the ST into
service. (This procedure is based on using STMON Rev J or later.)
For details on setting up and operating STMON see section B1 and B2. All
results must be entered on the Commissioning Test Result Sheet (see Appendix
2).
The table below shows the Part numbers and the Rev Level at which revised
programming (3 Digit RF Code) was introduced.
Product Part Number Revised programming
introduced at the following
Rev Level (3 Digit RF Code)
ST-V2 605-0000-411 Rev B
ST-V2 503-0700-144 Rev A
ST-V2 503-0700-149 Rev A
ST-V2 503-0700-134 Rev B
ST-V2 503-0700-129 Rev C
ST-V2 503-0700-136 Rev C
ST-D128 605-0000-536 Rev A
ST-D128 605-0000-538 Rev A
ST-D128 605-0000-334 Rev B
ST-D128 503-0700-127 Rev H
ST-D128 503-0700-140 Rev A
ST-I1 503-0700-141 Rev B
ST-I1 503-0700-128 Rev F
ST-I1 503-0700-139 Rev B
+ All CRUs in the 1.8-1.9Ghz Band
Note: Any other CRU part number or CRUs in the above list with a lower Rev
level should be programmed using the two digit RF Code.