User Manual

AS4000 Subscriber Terminal
Installation and Commissioning
DLP 006
605-0000-454
Draft Issue 1.3 Date 8/02/00
Page 1 of 6
SECTION 3:
INSTALLING THE R SERIES SERVICE INTERFACE
UNIT AND PSU.
The R series Service Interface Unit can be used as a free standing desk unit or wall
mounted to the customers’ preference.
Figure 30 The R series Service Interface Unit
STEP PROCEDURE
2. Installing The R series Service Interface Unit
1. Install the R series Service Interface Unit within 1 metre of an AC power point
and 50 metres of the Antenna. (100 metres if using 100m drop cabling).
2. Confirm the position of the Service Interface Unit (allow for adequate
ventilation and service access).
Note: The life of the batteries within the Service Interface Unit will be
increased in a low temperature, but standby time is improved in a warm
environment. Ideally the location should be cool, as the electronics within the
unit will keep it warm enough to ensure a good standby period.