User's Manual

Commissioning
183
Service Testing
On completion of the installation / panning of the ST perform an in service test to check that
the ST is capable of making voice and packet calls.
Voice Calls
1. Connect the test telephone to the SIU
2. Dial Tone Present. Lift the telephone handset of Line 1 Off-Hook, and confirm that
dial tone is heard in the handset receiver. If a comfort tone has been set check for
comfort tone prior to dial tone. Record on the 'Test Result' form.
3. Outgoing call. Initiate a call from the subscribers’ telephone to a test number
provided by the CT Office. Ensure that the call can be successfully set up and that
line quality is good.
4. Incoming call. Initiate a return call from the CT Office to the subscribers’ telephone.
Ensure that the call can be successfully set up and that line quality is good.
5. Test Calls. Repeat steps 2 to 4 for all other lines.
IP Check to Internet
1. Connect a Laptop/ PC equipped with a NIC card to the Ethernet Port of the ST
2. Connect using an internet browser.
3. Check that packets can be sent and received over the network
IP Check to Server
1. Connect a Laptop/ PC equipped with a NIC card to the Ethernet Port of the ST
2. Open the Command Prompt (start/programs/accessories/command prompt)
3. From the Command Prompt type ‘ping xxx.xxx.xxx.xxx’ where xxx.xxx.xxx.xxx is the
host server network address and check that a reply is received.