User's Manual

605-0000-595 Subscriber Terminal Installation and Commissioning
174
7. Channels may be removed by selecting the channel and clicking the remove button
for individual channels or using the clear all button to remove all channels.
8. Select the appropriate software bank to run the correct code version.
9. Select either AS4000 ST configure or AS4020 configure Cancel leaves the
configuration unchanged
10. When successfully configured the subscriber Terminal displays a confirmation
message.
Messages displayed if ST fails to configure.
1. The following messages may be displayed should and conflicting data is entered
whilst configuring STMON.
2. Some system administrators use a dongle attached to the serial port of the PC to
prevent the installation of STs by unauthorised persons. If the ST has been previously
programmed with a dongle different from the dongle attached, or if no dongle is
attached to the PC then a warning message is displayed.
3. If the Subscriber Terminal fails to configure because of conflicts between the mode of
working and the software bank then a warning message is displayed. Check that the
Assignment mode and the current bank software are compatible.
4. If the Subscriber Terminal fails to configure for any other reason the following screen
is displayed after 30 seconds.