User's Manual

Installation

AC Power Cord Installation

STEP PROCEDURE

Safety: Electric Shock: Risk of electric shock disconnect mains before opening the

PSU cover

Use a supply cord fitted with a mains plug in accordance with local requirements. Plug the AC

supply cord into the connector on the Type-7 PSU. Note. Do not connect the plug to the

supply socket until instructed to by the ‘Commissioning Test Procedure’.

Safety: Battery Handling

Care should be taken when handling lead acid batteries to avoid dropping or short circuiting

them. Disposal should be compliant with local codes. Batteries may explode if put into a fire.

Install the batteries in the PSU first, then connect them taking care to observe correct polarity.

Connect red lead to the +ve terminal and the black lead to the - ve terminal.

Disconnect Device. The socket outlet shall be installed near the equipment , easily

accessible and will act as the disconnect for the PSU.

PSU Labelling

If the PSU has been provided with a customer specific logo label, stick the label in the bottom

left hand corner of the front of the case as shown.

Customer Logo Placement