User's Manual

605-0000-595 Subscriber Terminal Installation and Commissioning

Drop Cable Termination Snap and Seal Connectors

Termination of 6 Series Drop Cable

1. Place cable into jaws of the stripper tool (if at outdoor unit end place sealing boot over the

cable first).

2. Rotate tool 4 turns clockwise then 2 turns anti-clockwise.

3. a) Remove cable from the stripper tool, discard waste and fold back braid.

b) insert cable firmly into the connector as far as possible.

4. Place connector in activator tool by pushing firmly against the spring loaded retainers.

5. Close the handles until the ratchet releases. The black indicator should not be visible if the

connector is correctly crimped.

6. Remove cable from the activator tool.