User's Manual

605-0000-595 Subscriber Terminal Installation and Commissioning
52
Installing the Outdoor Unit Using Bracket 605-0010-283
Use this procedure to install the outdoor unit. Before installing the 0utdoor Unit check that the
proposed position meets the site selection guidelines.
Country Specific Requirements
USA: In the USA the outdoor unit shall be installed in accordance with articles 725,
800, 810 and 820 of the National Electrical Code
Canada: In Canada the outdoor unit shall be installed in accordance with section 54 of
the Canadian Electrical Code
The Wall Mounting Kit comprises:
Item Quantity Use
Wall
mounting
Bracket
1 Fixed to
Building
M8 x 50mm
Coach Bolt
4 Fixing to
wood
M8 Plain
Washer
4
M6 Dyna
Bolt
4 Fixing to
brick/block
Cable Tie 3 Securing IF
Drop Cable
Outdoor Unit Positioning and Securing.
STEP PROCEDURE
1. Confirm the position of the outdoor unit ensuring that there is no obstruction in front
and to either side.
2. When multiple STs are deployed at the same site the recommended minimum
spacing between each outdoor unit is 1 metre.
3. The outdoor unit mounting bracket should be fixed so that panning can take place in
the horizontal plane (i.e. pole vertical). Check that line of sight with the Central
Terminal (CT) antenna does not breach the deployment rules.
4. Note: Leave adequate clearance around the outdoor unit wall mounting assembly to
allow for the full adjustment range when aligning the outdoor unit with the CT.