User's Manual

605-0000-595 Subscriber Terminal Installation and Commissioning
44
Required Tools and equipment.
1. Required Tools
The following lists of tools and equipment are required to successfully install and test the
Subscriber Terminal (ST) equipment.
General Tools
DESCRIPTION MODEL SIZE/Part No
Combination
Spanner
13mm
Ratchet and Socket 17mm
Spirit Level 18 inch
Screwdriver Pozidrive No 1 x 75mm
Screwdriver Pozidrive No 2 x
199mm
Screwdriver Pozidrive No 3 x
150mm
Screwdriver Flat Blade 3mm x
100mm
Hammer Ball Pein 1lb
Drill/driver Cordless – with depth
gauge
Hilti
Drill Bit Masonry 6mm
Drill Bit Masonry 10mm
Ladder – Triple Fully Extended 7 metre minimum
RG 6 Snap and Seal
Crimp Tool
166-8000-027
RG11 Snap and Seal
Crimp Tool
166-8000-030
Stripping Tool RG6 166-8000-028
Torque Wrench RG6 166-8000-021
Torque Wrench RG11 166-8000-033
Large side Cutters 166-8000-023
Screwdriver Pozi PH3 166-8000-018
ST Installation
Toolkit 605-0010-
313 used for Snap
and Seal
Connectors
consisting of a
Toolbox with the
following Items:
Laminated Instruction
Sheet
166-8000-031
RG 6 Round Crimp Tool 166-8000-020
RG11 Hexagonal Crimp
Tool
166-8000-019
Fixed Torque Wrench 166-8000-021
Screwdriver Pozi PH3 166-8000-018
Retractable Trimming
Knife
166-8000-022
Large side Cutters 166-8000-023
12" Steel Ruler 166-8000-024
Laminated Instruction
Sheet (RG6)
166-8000-025
ST Installation
Toolkit 605-0010-
257 consisting of a
Toolbox with the
following Items:
Laminated Instruction
Sheet (RG11)
166-8000-026
Required Equipment
The table below shows the required equipment.