User's Manual
Table Of Contents
- Installation
- Overview AS4000
- Overview AS4020
- Preparation
- Rack Installation
- AS4000 AC Rack Cabling and Wiring
- AS4000 CT Shelf Cabling and Wiring
- _
- Expansion Rack Cabling
- Setup and Test
- System Testing
- AS4000 AC Setup and Test
- Access Concentrator: Turn-Up and DC measurements
- Setting Up the Access Concentrator
- _
- Setting the TEI and Baud Rate for Netspan Connection
- Creating AC Shelf/Rack on Sitespan
- Setting up AC Rack and Shelf configuration
- Configure AC Cards
- Configure AC Shelf properties
- Check Boot Sequence
- Alarm and Status Indications (Test 3)
- Self Test (Test 4)
- Test CTU cabling to the DDF E1 Cards
- Test CTU cabling to the Distribution Frame (DDF) GR303 Cards.
- Test XTU cabling to the DDF
- Connecting the AC to the Network
- Connect E1s/T1s to the Switch or Cross-Connect at the DDF
- Access Concentrator Rack Commissioning Test Results
- AS4000 CT Setup and Test
- AS4020 CT Setup and Test
- _
- General
- Repair and Return Procedure
- Repair Charges
- Return & Repair Tag
- Packing and Shipment
- Glossary
- Index
Printed Documentation
84
12. Fit the cable tray immediately above the AS4020 shelf. Fix the shelf with two
cross head screws and locking washers.
13. Connect the IDC end of the combiner monitor connecting lead (454-0010-134) to
the IDC connector in the cable assembly 454-0010-137 added in step 8.
14. Connect part no 454-0010-135 to the 26way high density D-type labeled 'Radio'
on the front panel of the AS4020
15. For additional shelves connect cables as shown in the AS4020 installation
diagrams and follow the steps above where applicable.
16. Use a straight connected Ethernet cables to connect the patch panel /router/ IP
network/ etc to the Management Port and Traffic Ports.
17. Replace the covers removed from the combiner shelf.
18. Attach the front cover to the shelf tray(s)
19. Replace the side panels on the rack and secure with four retaining screws.
The unit is now ready for commissioning.
For details of interface connections see AS4020 Interface Connections
Note if installing more than one shelf the same instructions apply as above but the
connections will differ see the accompanying diagrams.