User's Manual
Table Of Contents
- Installation
- Overview AS4000
- Overview AS4020
- Preparation
- Rack Installation
- AS4000 AC Rack Cabling and Wiring
- AS4000 CT Shelf Cabling and Wiring
- _
- Expansion Rack Cabling
- Setup and Test
- System Testing
- AS4000 AC Setup and Test
- Access Concentrator: Turn-Up and DC measurements
- Setting Up the Access Concentrator
- _
- Setting the TEI and Baud Rate for Netspan Connection
- Creating AC Shelf/Rack on Sitespan
- Setting up AC Rack and Shelf configuration
- Configure AC Cards
- Configure AC Shelf properties
- Check Boot Sequence
- Alarm and Status Indications (Test 3)
- Self Test (Test 4)
- Test CTU cabling to the DDF E1 Cards
- Test CTU cabling to the Distribution Frame (DDF) GR303 Cards.
- Test XTU cabling to the DDF
- Connecting the AC to the Network
- Connect E1s/T1s to the Switch or Cross-Connect at the DDF
- Access Concentrator Rack Commissioning Test Results
- AS4000 CT Setup and Test
- AS4020 CT Setup and Test
- _
- General
- Repair and Return Procedure
- Repair Charges
- Return & Repair Tag
- Packing and Shipment
- Glossary
- Index
Installation
79
2 x PSUs. Slots 1 and 2.
1 x Shelf Controller Card
1 x Analogue Card (AU). Slot 16.
1 x Demand Assignment Tributary Card (DTU). Slot 5.
Modem Cards Slots 10 to15.
b) Shelf 2 (CT Rack) or Shelf 4 (Expansion Rack)
When installing cards into an existing installation the power is already connected and the
cards should be inserted in the order listed below.
Insert the following cards into the Combining Shelf:-
1 x RF Card (RF)(in slot 2 for modem shelf 2 or slot 4 for modem shelf 4)
Insert the following cards into the Modem Shelf:-
2 x PSUs Slots 1 and 2.
1 x Shelf Controller Card
1 x Analogue Card (AU) Slot 16.
1 x Demand Assignment Tributary Card (DTU).Slot 5.
Modem cards Slots 10 to15.