User's Manual
Table Of Contents
- Installation
- Overview AS4000
- Overview AS4020
- Preparation
- Rack Installation
- AS4000 AC Rack Cabling and Wiring
- AS4000 CT Shelf Cabling and Wiring
- _
- Expansion Rack Cabling
- Setup and Test
- System Testing
- AS4000 AC Setup and Test
- Access Concentrator: Turn-Up and DC measurements
- Setting Up the Access Concentrator
- _
- Setting the TEI and Baud Rate for Netspan Connection
- Creating AC Shelf/Rack on Sitespan
- Setting up AC Rack and Shelf configuration
- Configure AC Cards
- Configure AC Shelf properties
- Check Boot Sequence
- Alarm and Status Indications (Test 3)
- Self Test (Test 4)
- Test CTU cabling to the DDF E1 Cards
- Test CTU cabling to the Distribution Frame (DDF) GR303 Cards.
- Test XTU cabling to the DDF
- Connecting the AC to the Network
- Connect E1s/T1s to the Switch or Cross-Connect at the DDF
- Access Concentrator Rack Commissioning Test Results
- AS4000 CT Setup and Test
- AS4020 CT Setup and Test
- _
- General
- Repair and Return Procedure
- Repair Charges
- Return & Repair Tag
- Packing and Shipment
- Glossary
- Index
Printed Documentation
44
c) All other slot positions are configurable via Sitespan.
d) 3 CTUs are supported. Each CTU supports four CT modem shelves. Each CTU may
be cabled for eight 120 T1s. and are placed in slots 7, 8, and 9
e) XTUs (GR303, CAS, Data, ISDN, V5.1, V5.2 and PTU) are supported. Each XTU
may be cabled for eight 120 E1s. These can be placed in slots 8-14.(It is preferable
to build from slot 10 leaving 8 and 9 available for additional CTUs if required) and in
slots 4,5 and 6.
f) CU cards may go in any unused slot. (slots 15& 16 are preferred as they have no T1
connections.
g) RTU card can go in slot 9 or 17 for card redundancy using a spare TU8 card (not
PTU), the redundant card is selected via Sitespan.
Note If installing a PTU the D-type on the backplane must be fitted with a D-Type to
RJ45 adapter. The RJ45 to DB25 connector currently must be connected onto the
lower of the two 25-way AC connectors (even though the activity lights work if
connected to the top).
The preferred card positions are shown in the table below.