User's Manual
Table Of Contents
- Installation
- Overview AS4000
- Overview AS4020
- Preparation
- Rack Installation
- AS4000 AC Rack Cabling and Wiring
- AS4000 CT Shelf Cabling and Wiring
- _
- Expansion Rack Cabling
- Setup and Test
- System Testing
- AS4000 AC Setup and Test
- Access Concentrator: Turn-Up and DC measurements
- Setting Up the Access Concentrator
- _
- Setting the TEI and Baud Rate for Netspan Connection
- Creating AC Shelf/Rack on Sitespan
- Setting up AC Rack and Shelf configuration
- Configure AC Cards
- Configure AC Shelf properties
- Check Boot Sequence
- Alarm and Status Indications (Test 3)
- Self Test (Test 4)
- Test CTU cabling to the DDF E1 Cards
- Test CTU cabling to the Distribution Frame (DDF) GR303 Cards.
- Test XTU cabling to the DDF
- Connecting the AC to the Network
- Connect E1s/T1s to the Switch or Cross-Connect at the DDF
- Access Concentrator Rack Commissioning Test Results
- AS4000 CT Setup and Test
- AS4020 CT Setup and Test
- _
- General
- Repair and Return Procedure
- Repair Charges
- Return & Repair Tag
- Packing and Shipment
- Glossary
- Index
General
173
Defective Equipment Information Form
RMA Number (provided by Airspan)
Card/Assembly Description
Part Number and Revision (if Applicable)
Serial Number
Date Commissioned
Date Fault Reported
Location of Assembly in CT Rack
Shelf
Location of Subscriber Terminal
SUBSCRIBER TERMINAL INFORMATION
Power Supply Type (e.g. I, II or IV)
RX AGC Voltage
TX PC Voltage
ST Programming Code
Description of Fault
Comm Port OK?
Line Voltage Line 1?
Line 2?
CENTRAL TERMINAL INFORMATION
Card Type
Modem (Number)
TU
Analogue card
RF Card
Other (Specify Type)
Description of Fault
Sitespan Information
Packing and Shipment