User's Manual
Table Of Contents
- Installation
- Overview AS4000
- Overview AS4020
- Preparation
- Rack Installation
- AS4000 AC Rack Cabling and Wiring
- AS4000 CT Shelf Cabling and Wiring
- _
- Expansion Rack Cabling
- Setup and Test
- System Testing
- AS4000 AC Setup and Test
- Access Concentrator: Turn-Up and DC measurements
- Setting Up the Access Concentrator
- _
- Setting the TEI and Baud Rate for Netspan Connection
- Creating AC Shelf/Rack on Sitespan
- Setting up AC Rack and Shelf configuration
- Configure AC Cards
- Configure AC Shelf properties
- Check Boot Sequence
- Alarm and Status Indications (Test 3)
- Self Test (Test 4)
- Test CTU cabling to the DDF E1 Cards
- Test CTU cabling to the Distribution Frame (DDF) GR303 Cards.
- Test XTU cabling to the DDF
- Connecting the AC to the Network
- Connect E1s/T1s to the Switch or Cross-Connect at the DDF
- Access Concentrator Rack Commissioning Test Results
- AS4000 CT Setup and Test
- AS4020 CT Setup and Test
- _
- General
- Repair and Return Procedure
- Repair Charges
- Return & Repair Tag
- Packing and Shipment
- Glossary
- Index
Printed Documentation
134
Uplink Frequency Enter UL frequency kHz with leading 0 e.g 03522651
Channel Bandwidth 00002 (=3MHz)
PN Code PN code as supplied**
RF Commissioning
Mode 1 Note: If in commissioning mode the top menu
displays RF commissioning alarm
Card Type enter card type ( See number on RF card)
RX Sensitivity 02500
TX Power 03000
** The commissioning procedure described in this document is not restricted to any
particular RF channel or PN code. However the user should make sure that both the CT
and ST are programmed with identical RF channel and PN code. At the CT end, the RF
channel and PN code can be selected from the front panel in RF menu. In system
operating Release 7.2x once the user changes the PN code he needs to re-enable the
commissioning mode in order for this change to take effect properly. Release 7.30
however fixes this problem and the user should be able to change the PN code without
the need to re-enable the commissioning mode.