User's Manual
Table Of Contents
- Installation
- Overview AS4000
- Overview AS4020
- Preparation
- Rack Installation
- AS4000 AC Rack Cabling and Wiring
- AS4000 CT Shelf Cabling and Wiring
- _
- Expansion Rack Cabling
- Setup and Test
- System Testing
- AS4000 AC Setup and Test
- Access Concentrator: Turn-Up and DC measurements
- Setting Up the Access Concentrator
- _
- Setting the TEI and Baud Rate for Netspan Connection
- Creating AC Shelf/Rack on Sitespan
- Setting up AC Rack and Shelf configuration
- Configure AC Cards
- Configure AC Shelf properties
- Check Boot Sequence
- Alarm and Status Indications (Test 3)
- Self Test (Test 4)
- Test CTU cabling to the DDF E1 Cards
- Test CTU cabling to the Distribution Frame (DDF) GR303 Cards.
- Test XTU cabling to the DDF
- Connecting the AC to the Network
- Connect E1s/T1s to the Switch or Cross-Connect at the DDF
- Access Concentrator Rack Commissioning Test Results
- AS4000 CT Setup and Test
- AS4020 CT Setup and Test
- _
- General
- Repair and Return Procedure
- Repair Charges
- Return & Repair Tag
- Packing and Shipment
- Glossary
- Index
Setup and Test
113
3 Green Link failure Trinity 1 OFF
4 Green Link failure Trinity 2 OFF
5 Green Link failure Trinity 3 OFF
6 Green Link failure Trinity 4 OFF
7 Green Link failure Trinity 5 OFF
8 Green Link failure Trinity 6 OFF
9 Green Link failure Trinity 7 OFF
10 Green Link failure Trinity 8 OFF
11 Green Link failure Trinity 9 OFF
12 Green Link failure Trinity 10 OFF
13 Green Link failure Trinity 11 OFF
14 Green Link failure Trinity 12 OFF
DTU
Position
Colour Description Status
TOP
1
Red Card failure LED, which shall be alight if the
card self test fails, or if commanded by the
SC.
OFF
2 Green Card busy LED, to indicate live traffic is
present and should not be removed.
ON
3 Red/Yellow
E1/T1 port 1 Alarm *
4 Red/Yellow
E1/T1 port 2 Alarm *
5 Red/Yellow
E1/T1 port 3 Alarm *
6 Red/Yellow
E1/T1 port 4 Alarm *
7 Red/Yellow
E1/T1 port 5 Alarm *
8 Red/Yellow
E1/T1 port 6 Alarm *
9 Red/Yellow
E1/T1 port 7 Alarm *
10 Red/Yellow
E1/T1 port 8 Alarm *
LED Yellow if T1/E1 signal is being received with some other alarm condition. (e.g. remote
alarm or sync fail) being sent, Red if T1/E1 signal not received.
AU
Position
Colour
Description Status