User's Manual
Table Of Contents
- Installation
- Overview AS4000
- Overview AS4020
- Preparation
- Rack Installation
- AS4000 AC Rack Cabling and Wiring
- AS4000 CT Shelf Cabling and Wiring
- _
- Expansion Rack Cabling
- Setup and Test
- System Testing
- AS4000 AC Setup and Test
- Access Concentrator: Turn-Up and DC measurements
- Setting Up the Access Concentrator
- _
- Setting the TEI and Baud Rate for Netspan Connection
- Creating AC Shelf/Rack on Sitespan
- Setting up AC Rack and Shelf configuration
- Configure AC Cards
- Configure AC Shelf properties
- Check Boot Sequence
- Alarm and Status Indications (Test 3)
- Self Test (Test 4)
- Test CTU cabling to the DDF E1 Cards
- Test CTU cabling to the Distribution Frame (DDF) GR303 Cards.
- Test XTU cabling to the DDF
- Connecting the AC to the Network
- Connect E1s/T1s to the Switch or Cross-Connect at the DDF
- Access Concentrator Rack Commissioning Test Results
- AS4000 CT Setup and Test
- AS4020 CT Setup and Test
- _
- General
- Repair and Return Procedure
- Repair Charges
- Return & Repair Tag
- Packing and Shipment
- Glossary
- Index
Printed Documentation
112
Top 1 Amber Power/Module Status OK ON
2 Red Power Fault/PA Module 1 Fault OFF
3 Red Power Fault/PA Module 2 Fault OFF
* PA 2 is inserted inverted and the alarm indicators are also inverted
Power Supply Unit [PSU]
Position
Colour Description Status
Top 1 Amber Power OK ON
2 Red Power Fail OFF
Table. RF Combiner Shelf Card LED Indications.
Modem Shelf Card LEDs.
In normal state all LEDs will
MODEM
Position
Colour Description Status
TOP
1
Red Card failure LED, which shall be alight if the
card self test fails, or if commanded by the SC.
OFF
2 Green Card busy LED, to indicate live traffic is
present and should not be removed.
ON