User Manual

Sitespan User Guide Version 3.7
605-0000-426
Preface
Draft Issue 6.0. Date 4/4/00
Page 5 of 305
Safety Instructions - Warnings and Cautions
SAFETY
1. Read and follow all warning notices and instructions marked on the product or
included in this manual
2. Do not allow anything to rest on the power cord and do not locate the product
where persons could step or walk on the power cord.
3. When installed in the final configuration, the product must comply with the
applicable Safety Standards and regulatory requirements of the country in which it is
installed. If necessary, consult with the appropriate regulatory agencies and inspection
authorities to ensure compliance.
4. No hazardous RF radiation is emitted from the equipment. Measured at the
surface of the CRU radome, when transmitting, the maximum total power radiated
from the CRU is 0.01% of the UK National Radiological Protection Board basic
restriction per kg. of body part.
WARNING - HAZARDOUS VOLTAGES
On AC installations, hazardous voltages exist. Use caution when verifying or
working with AC power. Remove metal jewellery that could come into contact with
AC power.
On DC sections, short circuiting the low voltage, low impedance circuits can cause
severe arcing that may result in burns or eye damage. Remove rings, watches etc. to
avoid shorting DC circuits.
Electro-Static Discharge ESD
Electro-Static Discharge. Many circuits contain devices that are susceptible to
damage from high impedance voltage sources. To avoid such risks always follow
anti-static procedures where marked.