User Manual

AS8100 Sitespan User Guide Version 3.7
605-0000-426
DLP 112
Draft Issue 6.0. Date 4/4/00
Page 257 of 305
6. Each PSTN signalling time slot must be allocated a unique L3 address number (these must
also match those provided at the switch). Select each time slot in turn and enter the L3
address number.
7. Provision channel by clicking left mouse button in check box next to the provisioned script,
a tick shows that the channel is provisioned.
8. When all parameters have been set for each timeslot click left mouse button on the OK
button. If any conflicts occur in the configuration of any of the L3 addresses an error
message is displayed. An example of an error message is shown below. If there are
multiple conflicts acknowledging a conflict reveals another conflict window. The object
model is not changed until the conflicts have been resolved.
9. If special signalling features are required, click the Configure button to access the Global
Object Container. Select V5.1 TU signalling. Choose existing pre-defined parameters or
create a new object and enter the new parameters (See DLP-115).
10. Repeat for other E1 ports and 5.1 cards.
ISDN
11. Set the Port (Basic Rate Access Circuit) and EF addresses Number (these must match those
provided at the switch). The S, P and F type C paths can use the same timeslot Common
Channel signalling path as the PSTN or may use a different time slot (these must match
those provided at the switch).
12. When all parameters have been set click left mouse button on the OK button. If any
conflicts occur in the configuration of any of the timeslots, ports or EF addresses an error
message is displayed. An example of an error message is shown below. If there are