User Manual

AS8100 Sitespan User Guide Version 3.7
605-0000-426
DLP 112
Draft Issue 6.0. Date 4/4/00
Page 256 of 305
Set the Channel Parameters
3. Enable Channel by clicking left mouse button in check box, a tick shows that the channel is
enabled.
4. Click left mouse button on the radio button to select the impedance (75 or 120 ohm) for
each link. Enter a unique Interface ID and Variant Number (these must match those
provided at the switch). Select the service type (PSTN, ISDN or Mixed). Note: The display
reflects the configuration chosen and requests further information for signalling as
appropriate.
Set PSTN Parameters
5. Select the signalling timeslots used to provide signalling back to the switch 15,16, and 31.
If 15 or 31 are chosen the timeslots are not available for calls and are not selectable from
the timeslot drop list. The timeslots chosen for signalling must match the timeslots chosen
at the switch.