User Manual

AS4000 Operations and Maintenance
Section
605-0000-431
6
. Issue 1.6. Date3/2/99
DLP-019
Page 39 of 60 © Copyright Airspan Communications Corporation 1999
Programming 12 and 16kHz SPM tones
1. With the RF channel information accepted there is a further process to select
the SPM frequency option. This should be done on all new voice. The
command supports options for 12kHz or 16kHz Subscriber Private Metering
(SPM) on voice STs.
1. To program voice CRUs with the required SPM option repeat steps 7 to 8 above and enter the
required SPM option code digits. The format has 5 numbers starting with # as shown below.
1 2 3 4 5
# <n> <n> <n><check digit>
Characters 2,3,4 are the options code ( range 000 to 255). Character 5 is the
checksum – calculated the same as the RF channel checksum.
The Only options are:
16kHz SPM has been assigned to option code 000
12kHz SPM has been assigned to option code 001
Hence: 16kHz SPM is programmed with #0009 and 12kHz SPM is programmed
with #0010
Table 4. Function Key Description
Key Name Function
F1
Open Opens STMON communication between the PC and ST.
Press F1 if connecting to an ST that is already powered up
and operating.
F2
Close Closes STMON communication between the PC and ST.
Press F2 before disconnecting from an ST.
F3
Install
Invokes the ST-V2 install mode. Not valid for ST-I1 / ST-
D128
F4
Install
Invokes the ST-I1 and D-128 install mode. It can also be
used to program ST-V2 without a telephone attached.
Press F4 and. Enter he ST channel code by pressing the
appropriate digits on the keyboard. When complete wait for
the ST to reboot. Check that the correct channel code is
displayed in the Build Status panel.
F5
Help Displays the help menu. This shows how to program STs that
support the new 3 digit RF channel code and old 2 digit RF
channel code. It also shows how to program the ST options.
ESC
Quit Exits the STMON application.
STOP. THIS PROCEDURE HAS BEEN COMPLETED.