User Manual

AS4000 Operations and Maintenance
Section
605-0000-431
6
. Issue 1.6. Date3/2/99
DLP-019
Page 37 of 60 © Copyright Airspan Communications Corporation 1999
PROGRAMMING THE CRU USING STMON
The following procedure will have to be completed before placing the ST into
service. (This procedure is based on using STMON Rev J or later.)
New versions of the CRU require STMON Version J or later as the have an
extended information field to cater for the increased range of RF Frequencies used
by the AS4000 System. Version J is also compatible with older versions of the
CRU
For details on setting up and operating STMON see DLPs 011 and 012. All
results must be entered on the Commissioning Test Result Sheet, see DLP-019.
The table below shows the Part numbers and the Rev Level at which revised
programming (3 Digit RF Code) was introduced.
Product Part Number Revised programming
introduced at the following
Rev Level (3 Digit RF Code)
ST-V2 605-0000-411 Rev B
ST-V2 503-0700-144 Rev A
ST-V2 503-0700-149 Rev A
ST-V2 503-0700-134 Rev B
ST-V2 503-0700-129 Rev C
ST-V2 503-0700-136 Rev C
ST-D128 605-0000-536 Rev A
ST-D128 605-0000-538 Rev A
ST-D128 605-0000-334 Rev B
ST-D128 503-0700-127 Rev H
ST-D128 503-0700-140 Rev A
ST-I1 503-0700-141 Rev B
ST-I1 503-0700-128 Rev F
ST-I1 503-0700-139 Rev B
+ All CRUs in the 1.8-1.9Ghz Band
Note: Any other CRU part number or CRUs in the above list with a lower Rev
level should be programmed using the two digit RF Code.