User Manual

AS4000 Subscriber Terminal
Installation and Commissioning DLP 018
605-0000-436
Issue 1.4 Date 11/4/99
Page 35 of 60 © Copyright Airspan Communications Corporation 1999
Table 14. Function Key Description
Key Name Function
F1
Open Opens STMON communication between the PC and ST.
Press F1 if connecting to an ST that is already powered up
and operating.
F2
Close Closes STMON communication between the PC and ST.
Press F2 before disconnecting from an ST.
F3
Install
Invokes the ST-V2 install mode. Not valid for ST-I1 / ST-
D128 With a telephone attached to either VF pairs, press F3
and lift the telephone handset. The install ‘ready to proceed’
tone is heard. The ST channel code may the be entered by
pressing the appropriate digits on the telephone handset.
When complete, hang up and wait for the ST to re-boot.
Check that the correct channel code is displayed in the Build
Status panel.
F4
Install Invokes the STMON install mode. There are 2 install
options, the RF channel/PN/RW installation and ST options
installation.
A cursor appears in the Program Data panel.
1. RF Channel/PN/RW install
Enter the ST programming code, e.g. 101207*9, then press
<ENTER>.
2. ST options install
Enter the 3 digit ST install option code, eg #0009, then press
<ENTER>
In both cases the digits will be sent to the ST. If the ST
accepts the digits a message will appear 'ST Install OK'
otherwise either 'ST Install Failed' or 'No response' will
appear.
When complete, wait for the ST to re-boot. Check that the
correct channel code or st options are displayed in the Build
Status panel.
F5
STMON
Help
Displays the help menu. This shows how to program STs that
support the new 3 digit RF channel code and old 2 digit RF
channel code. It also shows how to program the ST options.
ESC
Quit Exits the STMON application.