User Manual

AS4000 Operations and Maintenance

Section

605-0000-431

. Issue 1.6. Date3/2/99

DLP-017

Page 26 of 60 © Copyright Airspan Communications Corporation 1999

5. Programming Sequence

Depress the Programming switch SW3(S2 in early versions). Lift the telephone

handset Off-Hook and wait for the 3 sec continuous “programming start” tone

of 1400 Hz, to be heard in the handset receiver.

Enter the respective ST programming code on the telephone keypad, within 40

seconds of depressing the install switch.

6. Code Acceptance

Should an incorrect programming code be entered, an “incorrect code” tone

shall be heard in the handset receiver, which consists of 1400 Hz pulses for less

than 1 sec on, and less than 1 sec off, for a duration of 5 sec.

Ensure that at the end of the programming sequence, the “code accepted” tone

is heard in the handset receiver, which consists of 1400 Hz pulses for 1 sec on;

1 sec off, for a duration of 5 sec.

Replace the telephone handset.

If the ST fails to accept the programming code after a second attempt, confirm

with the network planning staff that the correct code is being used.

Should the ST still fail to accept the code, the ST will need to be replaced.

7. Equipment Reset

Depress the reset switch, SW4(S1 in early versions); The CRU will reset and

re-boot itself in accordance with the programming code entered.

8. Replace and secure ACPSU cover. (leave cover off if going to DLP-020).

STOP. THIS PROCEDURE HAS BEEN COMPLETED.