User Manual

AS4000 Central Terminal
Installation and Commissioning
GSI 002
605-0000-452
Issue 1.3dr Date 7/02/00
Page 1 of 1 © Copyright Airspan Communications Corporation 2000
OVERVIEW
1. Installation Tasks
The installation procedures are arranged as a series of tasks and are generalised to cover
the majority of applications and configurations. If your particular system application is
not covered, call the ACC Help Desk, for assistance at the following number: 44 (0)1527
402800
It is recommended that the tasks be completed in the sequence listed below:
• Task 1 — Verify Site facilities
• Task 2 — Unpack and Inspect Equipment
• Task 3 — CT Rack Installation
• Task 4 — System Interface Cabling
• Task 5 — Module/Card insertion
• Task 6 — System Test
• Task 7 — Test Results
• Task 8 — Connection to management system.
• Task 9 — Work Area Inspection and Cleaning
• Task 10 — Acceptance Procedure
2. Safety
Personnel installing the ACC AS4000 System should follow ACC safety
procedures W090 0001 001 Issue 01 April 96
2.1. Electromagnetic Radiation
When working on the CT and Antenna, do not remove coax feeder connectors
when the unit is operating.
No hazardous RF radiation is emitted from the equipment. When transmitting, the
maximum total power radiated from each CT aerial is equal to the level of the UK
National Radiological Protection Board basic restriction per kg of body part. At the
surface of each aerial radome, the power flux density is approximately one fifth of the
investigation level of the UK National Radiological Protection Board.