Installation Guide

AirSynergy Equipment Installation Guide
Page 7 Commercial in Confidence SYN-UG-007 Rev A0.41
Figure 54 – Fix the PSU into position using self tapping screws ......................................................... 43
Figure 55- BS Config ............................................................................................................................. 45
Figure 56- Mgmt IP Config .................................................................................................................... 46
Figure 57- Reboot Confirmation ............................................................................................................ 47
Figure 58- Discovery Tasks .................................................................................................................. 47
Figure 59- Edit Discovery tasks parameters ......................................................................................... 48
Figure 60 - Discovery Target................................................................................................................. 49
Figure 61 - Discovery Test .................................................................................................................... 49
Figure 62 - Removing the existing stud mounting plates ...................................................................... 52
Figure 63 - Fitting the stud joining plates .............................................................................................. 52
Figure 64 - Position back to back assembly on side to tighten all joining plate screws....................... 53
Figure 65 - Mounting method with pole clamps recommended for back to back installations ............. 53
Figure 66 - Flatten straps against the mounting plate for back to back installations ........................... 54
Figure 67 - Back to Back AirSynergy mounted on pole with 4 mounting straps ................................... 54
Figure 68 – M6 Screw fixing point as safety line anchor point.............................................................. 55
Figure 69 – AirSynergy Mains PSU and enclosure for USA deployments ........................................... 58
Figure 70 – 48V DC cable attached ready for connection to the PoE injector ..................................... 58
Figure 71 – Internal PSU and and cable terminations .......................................................................... 59