Installation Guide

AirSynergy Equipment Installation Guide
Page 55 Commercial in Confidence SYN-UG-007 Rev A0.41
Mount the assembly on the universal mounting bracket and secure the flange nuts. The GPS antenna
and front mount antenna if used can be fitted before or after mounting to the pole depending on ease
of access.
In cases where no front mount antenna is fitted, an extended sun shield is available as an accessory
item and should be fitted. The fitting method is the same as the standard sun shield with 3 fixings on
each side of the front AirSynergy unit.
Follow the normal procedures for the connection of power supply units and drop cabling to each of the
back to back mounted AirSynergy units.
Note: When securing back to back assembly to the mounting plate a safety line or
rope should be secured to the units. The 6mm tapped holes used for the
protection ground at the bottom or the GPS mountings at the top of each Synergy
unit provide strong anchor points for a safety line. (This is the same point used
for protection ground connection in exposed areas or high lightening risk areas)
Figure 68 – M6 Screw fixing point as safety line anchor point