Installation Guide

AirSynergy Equipment Installation Guide
Page 5 Commercial in Confidence SYN-UG-007 Rev A0.41
Summary of Figures
Figure 1 – Typical AirSynergy with sun shield ..................................................................................... 11
Figure 2 – AirSynergy with front sector antenna fitted .......................................................................... 11
Figure 3– AirSynergy with Switched Beam Antenna ............................................................................ 12
Figure 4 – AirSynergy dual unit “back to back” configuration (External GPS antenna fitted) ............... 12
Figure 5 – Workflow of AirSynergy Installation .................................................................................... 13
Figure 6 – AirSynergy unit in typical packing box as supplied .............................................................. 19
Figure 7 – AirSynergy unit (connectorised) .......................................................................................... 19
Figure 8 – AirSynergy unit with Switched Beam Antenna (factory fitted) ............................................. 19
Figure 9 – Universal Mounting Plate and pole straps .......................................................................... 20
Figure 10 – Sun Shield with fixings ....................................................................................................... 20
Figure 11 – Sector Antenna Mounting plate and fixings ....................................................................... 20
Figure 12 – Sector Antenna (Check frequency variants) ...................................................................... 20
Figure 13 – GPS antenna ..................................................................................................................... 21
Figure 14 – GPS antenna mounting kit ................................................................................................. 21
Figure 15 – AirSynergy mounting plate and fixings ............................................................................ 22
Figure 16 – Feed clamp bands through the quick release locking mechanisms ................................. 22
Figure 17 – Press down the locking mechanism with the slack band fed through .............................. 22
Figure 18 – Tighten clamps with large flat blade screwdriver ............................................................... 23
Figure 19 – AirSynergy mounting plate installed (large diameter concrete pole) ................................. 23
Figure 20 – Fixing the front mount antenna to the mounting plate ....................................................... 24
Figure 21 –Fitting the Front mount antenna assembly to AirSynergy .................................................. 24
Figure 22 –Fitting the GPS antenna to the mounting bracket ............................................................... 25
Figure 23 –GPS antenna cable connected ........................................................................................... 25
Figure 24 – Assembling the GPS antenna and bracket assembly to AirSynergy ................................. 26
Figure 25 – Lift AirSynergy to top of pole-mount plate ........................................................................ 26
Figure 26 – AirSynergy drops down into slots at the top of pole-mount plate .................................... 27