Installation Guide

AirSynergy Equipment Installation Guide
Page 45 Commercial in Confidence SYN-UG-007 Rev A0.41
7 Set BS Management IP & BSID via Web Page
The following are the steps to the BS via its WEB interface.
Ensure that your Web browser with which you want to access the Web-based Management is active.
To connect to AirSynergy via the WEB interface:
1. Open web browser ant type the BS address.
IP address – 192.168.0.100 (255.255.255.0)
User name – synergy
Password – synergy
2. Click Submit
3. For WiMAX 16e applications Navigate to “General” menu to specify the BS ID. (Format
xxxxxx:yyyyyy)
Where xxxxxx is reserved for the Operator ID and yyyyyy is a unique Hexadecimal reference
number within the network. The commissioning details vary for iBridge and LTE applications and
these are covered in separate commission documents
Figure 55- BS Config
4. Click Save.
Note: iBridge Term menu item is not applicable to 16e BS and must not be
used. Configuration of “RF Channels” may lead to failed installation (failed
commissioning and no discovery). Configuartion details for iBridge is covered in
a separate document
Write the BS ID