Installation Guide

AirSynergy Equipment Installation Guide
Page 15 Commercial in Confidence SYN-UG-007 Rev A0.41
3.4.2 Adhere to European Directive 1999/519/EC
European Council Recommendation1999/519/EC details basic restrictions and reference levels on
human exposure to electromagnetic fields as advised by the ICNIRP. Adherence to these
recommended restrictions and reference levels should provide a high level of protection as regards
the established health effects that may result from exposure to electromagnetic fields.
3.5 Verify Installation Requirements
3.5.1 Verify the Tools
Table 1 - AirSynergy installation tools
Tools
Small flat blade Screwdriver
(For screw terminals inside PoE injector)
Large Flat Bladed Screwdriver
(Securing of the pole straps)
Medium Cross-head Screwdriver
(PoE injector lid and mounting screws)
13mm wrench x 2
(Heavy-duty pole clamp option only)
10mm wrench
(AirSynergy securing flange nuts)
Large pliers
(Tightening cable glands on the PoE injector - To fit 15mm across flats)
Knife (for stripping back insulation)
Tweezers (or fine tipped long nose pliers)
Wire cutters
Wire strippers
(Cutting insulation)
Ring terminals crimp tool