Installation Guide

AirSynergy3 Equipment Installation Guide
Page 6 | Commercial in Confidence SYN-UG-018
Figure 29 – AirSynergy drops down into slots at the top of pole-mount plate .......................... 27
Figure 30 – Gently lift the AirSynergy body until the bottom studs engage in the bottom slots
.............................................................................................................................................................. 27
Figure 31 – AirSynergy body engaged in the bottom slots ............................................................ 27
Figure 32 – AirSynergy downtilt adjustment .................................................................................... 28
Figure 33 – Tighten flange nuts (4 positions) once the required mounting angle is set ............. 28
Figure 34– AirSynergy attachment of earthing cable ..................................................................... 29
Figure 35– Attach earth cable to pole ............................................................................................... 29
Figure 36 – Connecting the antenna RF cables .............................................................................. 31
Figure 37 – AirSynergy Front mount antenna connections – applying self -amalgamating tape
.............................................................................................................................................................. 31
Figure 38 – AirSynergy antenna connections – applying PVC tape ............................................. 32
Figure 39 – Attach the power cable to the AirSynergy ................................................................... 32
Figure 40 – Tools required to connect the PSU ............................................................................... 33
Figure 41 – AirSynergy3 power and network cable overview diagram ........................................ 34
Figure 42 – Preparing the end of the drop cable ............................................................................. 35
Figure 43 – Water proof power connector with the 2 halves separated ........................................ 35
Figure 44 – Waterproof connector dis-assembled ready for installation on the cables ............. 35
Figure 45 – Cable gland and connector body positioned on the drop cable. ............................... 36
Figure 46 – Fit the cable ends into the connector and secure ....................................................... 36
Figure 47 – Male part of connector with both drop cable wires fitted ........................................... 36
Figure 48 – Connector contact position markings .......................................................................... 37
Figure 49 – Assemble the connector and tighten the gland ........................................................... 37
Figure 50 – Prepare the ends of the PSU cable and thread the connector part over the cable .. 37
Figure 51 – Female part of connector with both PSU cable wires fitted ....................................... 38
Figure 52 – Assemble the connector ad tighten the sealing gland .............................................. 38
Figure 53 – Connector parts joined together .................................................................................. 38
Figure 54 - High power (240W) PSU showing the Mains and low voltage connections .............. 39
Figure 55 – Standard power (100W) PSU .......................................................................................... 39
Figure 56 – Fix the PSU into position using self tapping screws ................................................. 39