Installation Guide

AirSynergy3 Equipment Installation Guide
Page 44 | Commercial in Confidence SYN-UG-018
6 Automatic Discovery via Netspan
Set BS discovery profile in Netspan.
The following section explains the steps to take for the automatic discovery of AirSynergy via
Netspan.
To connect to AirSynergy BS via Netspan
1. Login to Netspan
2. Navigate to Server > Discovery Parameters
The following is displayed:
Figure 60- Discovery Tasks
3. Click Add
4. Define:
a) Name.
b) Write Community.
c) Read Community
Note: This should be same as was configured before on the BS.
5. Define the discovery Target IP Address Range. For example – Start address = 172.30.0.100
and End Address=172.30.0.101
6. Port – enter 161
7. Click OK, as shown below:
8.