Installation Guide

AirSynergy Equipment Installation Guide
Page 18 Commercial in Confidence SYN-UG-007 Rev 1
6 Fit Front sector antenna to AirSynergy
The AirSynergy unit can be used either with a sector antenna mounted directly on the front or with a
remotely attached RF antenna.
6.1 Mount Front antenna to the AirSynergy unit
To mount the front antenna , perform the following steps:
Add text here to describe the mounting of the antenna to the front mount plate, securing of the
antenna cables with cable ties and the fitting of the antenna plus front mount plate to the front of the
AirSynergy unit.
Figure 8 – AirSynergy front mount antenna and front mount plate
Figure 9 – Connecting the antenna RF cables
Caution: Do not over-tighten the RF connector. RF failures can result when the
RF connector is over-tightened.
Weather-proofing of the RF N type connectors with weather-proofing tapes. (self amalgamating
followed by a layer of balck PVC tape.