User's Manual

HiperMAX Masthead Equipment Installation Guide
Page 49 Commercial in Confidence UGD-D00093 Rev A.1
12 Appendix D – Checklist
The Checklist below gives the high-level steps in the Workflow for this procedure. Detach or print this
page to use as a job-aid for completing the actions this procedure requires.
Procedure
Actions
Outcome
1. Verify Prerequisites
1.1 Verify site
requirements
1.2 Verify safety
requirements
1.3 Verify installation
requirements
All requirements are in
place for a successful
installation or upgrade to
new version of Netspan.
2. Install SCRT plate
mount
2.1 Mount the SCRT
2.2 Verify connection
torque settings
3. Install SCRT pole
mount
3.1 Mount antenna to
SCRT
3.2 Mount SCRT and
antenna to pole
4. Connect and manage
cables
4.1 Connect HiperMAX
4.2 Connect HiperMAX-
micro
4.3 Connect optic
interface for HiperMAX
ATCA.
4.4 Install GPS antenna
4.5 Connect GPS 1 pps
4.6 Connect GPS
10MHz out
4.7 Connect optic
interface to SCRT
5. Connect power system
5.1 Power output to
SCRT
5.2 Run Cables to
SCRTs connectorised at
both ends
Table 10 – Checklist for Procedure