User's Manual
HiperMAX Masthead Equipment Installation Guide
Page 41 Commercial in Confidence UGD-D00093 Rev A.1
9 Appendix A
9.1 Review Job Sheet
The Job Sheet should include the following information:
BS location and ATCA rack identity.
Whether the system is required to be locked to a GPS timing reference.
Whether the SDR is to be a Primary Master, Secondary Master or a Slave. This
information will be mapped to the ATCA rack slot number by this procedure.
A BSID is required for each SDR Blade. This should be in a format xxxxxx:xxxxxx where x
is a decimal digit.
The mapping of SCRT ID to OBSAI port ID on the SDR blade.
Network configuration information for the SDR blade. This shall include the following
information for the front panel and the backplane.
Traffic Port: Defines whether traffic is via the front panel of the SDR blade, Primary
Backplane or Secondary backplane.
IP Address: Should only be set if Management IP Mode is set to Static IP Address. See
below for Management IP Mode parameter.
Netmask: Should only be set if Management IP Mode is set to Static IP Address. See below
for Management IP Mode parameter.
Default Gateway: Should only be set if Management IP Mode is set to Static IP Address.
See below for Management IP Mode parameter.
Management VLAN: Specified as either Untagged or Tagged
Management VLAN Tag: Should only be set if Management VLAN is set to Tagged
Management IP Mode: Specified as Static IP Address or Obtain IP Address via DHCP
Ethernet Mode: Specified as Autonegotiate or Fixed
Ethernet Rate: Need only be configured if Ethernet Mode is set to Fixed, specified as 10M or
100M.
Ethernet Duplex: Need only be configured if Ethernet Mode is set to Fixed, specified as Full
or Half.
SNMP configuration information. This will allow events from the BS to arrive at the
specified Netspan server. This will include the following information:
Read Only Community: This should be specified to the same value as in Netpans Discovery
Parameters (found under Server on Netspans left hand panel).