User's Manual

HiperMAX Masthead Equipment Installation Guide
Page 38 Commercial in Confidence UGD-D00093 Rev A.1
This interface is used to provide 10MHz clock between a HiperMAX-micro master SDR and a
HiperMAX-micro slave SDR.
A 1.5 metre connecting cable (terminated at both ends with TNC connectors) is provided with a slave
BS.
7.7 Connect Optic Interface to SCRT
Each SCRT is provided with various metre optical fibre cable, ready terminated with optical
connectors. Unscrew the protective dust cap and screw the fibre optic cable in place.
1. Attach the fibre and DC cables to the connectors on the termination panel of the SCRT as
shown below.
Figure 24 – HiperMAX-micro SCRT attach cables to termination panel
2. Cable and connect:
o Optical
o Power
o GPS
For a detailed description of the correct installation practices specific to the
connections to the HiperMAX ATCA and Micro Installation Guides available on
the Airspan share methods site.