User's Manual

HiperMAX Masthead Equipment Installation Guide
Page 37 Commercial in Confidence UGD-D00093 Rev A.1
Figure 23 – HiperMAX GPS antenna bracket
1. The RJ58 antenna cable is provided with a TNC connector attached at each end. Run the
cable from the SDR-micro or HiperMAX GPS receiver to the location of the GPS antenna.
2. Thread the TNC connector cable through the threaded tube on the bracket and attach the
TNC connector to the Antenna.
3. Connect the tube to the antenna by holding the antenna firm and rotating the bracket around
the cable until the thread is fully engaged in the threaded part of the antenna.
4. Connect the bracket to the pole using the two U bolts and tightening with a 10mm spanner.
7.5 Connect GPS 1 pps
Checkpoint: If the HiperMAX-micro GPS is specified for this installation, follow
this instruction. Otherwise, exit this instruction and proceed to the next one.
This interface is used to provide 1 pulse /sec synchronisation between a HiperMAX-micro master
SDR and a HiperMAX-micro slave SDR.
A 1.5 metre connecting cable (terminated at both ends with TNC connectors) is provided with a slave
BS.
7.6 Connect GPS 10MHz out
Checkpoint: If the HiperMAX-micro GPS is specified for this installation, follow
this instruction. Otherwise, exit this instruction and proceed to the next one.