User's Manual

HiperMAX Masthead Equipment Installation Guide
Page 26 Commercial in Confidence UGD-D00093 Rev A.1
Figure 9 – HiperMAX-micro antenna and mounting studs
2. Place the SCRT on a flat surface with the RF connector facing up as shown in image below.
Figure 10 – HiperMAX-micro SCRT antenna bracket mounting holes
3. Place the antenna on top of the SCRT so that the RF connector on the antenna mates with
the RF connector on the SCRT
Caution: Do not over-tighten the RF connector. RF failures can result when the
RF connector is over-tightened.