User's Manual

6. Source LED: Shows which source is currently playing
7. Status: Blue shows the soundbar is on.
Red shows standby.
(The light will flash when a button is pressed on the
remote or on the control panel.
Hint: Long press the power button to reset the soundbar. This will reset
the source, volume, treble and bass memory to factory default settings.
Press and hold for 3 seconds. The soundbar will confirm by flashing the
power/status light 3 times. The unit will reset and optical source will be
selected.
Getting Started
Setting up
1
Connect power
2
Switch on power
2
1
1
1
1
2
3
Check subwoofer volume
3
Spatial Soundbar with Bluetooth and Wireless Subwoofer
©2013 Orbitsound ltd. Model: M10
To prevent electric shock,
do not remove screws.
No User serviceable
parts inside.
CAUTION:
DC in 22V 2.5A
Made in China
Approved components used
ON OFF
OPTICAL
AUX IN
Stereo
Line In
POWER
WIRELESS
1
1. Connect the power supply and mains cord to the soundbar. The
subwoofer connects directly to the mains via a mains cord (all cables
included).
2. Switch on the power on both the soundbar and subwoofer.
3. Check the volume setting on the subwoofer. Point this to normal. You
can adjust this later as preferred.
Hint: See advanced setup for more information on (3) subwoofer level.
For the moment, set it to ‘normal’