Instruction Manual

AirSep

Corporation

NewLife

Intensity

III. CLEANING - MAINTENANCE

III. 1. Cleaning

Only the outside of the NewLife

Intensity is to be cleaned, with a dry cloth or, if necessary,

a damp sponge and clean or soapy water, then thoroughly dried with wipes and an alcohol-based

solution. Acetone, solvents or any other ammable products must not be used. Do not use

abrasive powders.

The removable dust lter (9) must be cleaned in soapy water after

approximately 100 hours of use, or when required. Rinse and

wipe dry. Fit a dry lter.

III. 2. Everyday disinfection

Due to the presence of the product lter inside the device,

everyday disinfection only concerns the external oxygen therapy

accessories: humidier, probes, nasal cannulas (refer to the respective instructions for use).

The use of alcohol-based solutions means that the device must be

switched off.

a - The following minimum guidelines must be respected:

• Humidier :

Daily:

- empty the water from the humidier.

- rinse the humidier ask under running water.

- Fill the humidier up to the mark with slightly mineralised water.

Regularly:

- Disinfect the equipment by immersing them in a disinfectant solution (in general, we recommend

using water containing a small amount of chlorine bleach).

- Rinse and dry.

- Check that the humidier lid seal is in good condition.

• Oxygen administration devices:

Follow the manufacturer’s instructions.

b - For each new patient:

The humidier must be sterilised if possible or changed. The NewLife

Intensity must be

cleaned and disinfected as per the above instructions. The dust lter should preferably be changed.

The entire oxygen administration circuit (oxygen therapy nasal cannulas, etc.) must be changed.

4-GB