User`s manual

TROUBLE CHECK REMEDY

●

Power plug incorrectly connected

● Connect plug correctly

● POWER button “OFF” ● Press POWER button to “ON”

● Fuse (supply) blown ● Replace fuse

● Breaker on switch board ● Check load capacity and reset

tripped

● Ambient temp. too high ● Use only below 113℉,45

℃

(over 113℉,45℃)

● Filter blocked with dust ● Clean Filter

● Dust in heat exchanger ● Clean heat exchanger

● Obstacle against inlet side ● Remove and allow 20" (51 cm) clearance

● Ambient temp. too high ● Use only below 113℉,45

℃

(over 113℉,45℃)

1. To remove EVA filters, open the front grille ①

and pull the filter inside ②.

2. To remove COND filters, slide up a little ① and

pull towards you ②.

3. Clean the filters with water or compressed air.

4. Clean evaporator and condenser units with a

vacuum cleaner or compressed air.

1. After cleaning, completely dry

the inside of the unit by

operating on ‘Fan Mode’

for 3 to 4 hours.

2. Turn “OFF” at control panel,

remove plug from socket. Coil

and store cable neatly.

3. Keep machine suitably covered to

prevent damage by damp,

humidity and dust.

MAINTENANCE

CLEANING THE AIR FILTERS

MAINTENANCE

rev0

Operating Instruction & Parts Manual

NOT

WORKING

POOR

COOLING

TROUBLESHOOTING CHART