Installation Manual

4 484 01 3905 03
Specifications subject to change without notice.
Self- Tapping Screws
A13065
Figure 4 - Hori zont al Right I nst al l at ion
3. Connect furnace snugly against coil casing.
4. Use self- tapping screws to attach furnace. (See
Figure 5)
5. Seal joint between coil casing and furnace to create an
air tight seal using locally approved materials.
6. Use cork tape to create air seal between the undersides
of the pan extension and front of the vertical drain pan as
shown in Figure 6.
7. Install included condensate pan extension and two
corner screws as shown in Figure 7.
8. If coil is wider than furnace, use 4- in minimum transition
and self tapping screws to attach furnace. (See Figure 2)
A13063
Figure 5 - Hori zont al Right I nst al l at ion
A170282
Figure 6 - Condensate Pan Extensi on Cor k Tape Location
A170283
Figure 7 - Condensate Pan Extensi on Mount i ng Scr ews
Horizontal Left Installation
1. Unbend the 4 tabs at the right side of the casing. (See
Figure 8)
2. Connect furnace snugly against coil casing.
3. Use self- tapping screws to attach furnace. (See
Figure 9)
4. Seal joint between coil casing and furnace to create air
tight seal using locally approved materials.
5. If coil is wider than furnace, use 4- in. Minimum transition
and self tapping screws to attach furnace. (See Figure 2)