User Manual

R
L
R
L
Connect to playback devices
Connect to power source
Speaker placement
109
AIRPULSE P100X
Bluetooth
Preparaons
Playback instrucon
CD player/music player
/audio decoder, etc.
PC or Mac
CD player
RCA audio cable
2.Bluetooth input: Please switch to Bluetooth input mode, and set your Bluetooth device to search
for and connect to "AIRPULSE P100".
Note:
1.The baery life is normally about 6 months; please replace it when the remote control is
not sensive or the control distance to be shortened.
2.Remove the baery immediately when exhausted to avoid explosion or acid leaks.
3.Discard the baery immediately in the event of baery leakage, paying aenon not to
touch the leaking materials.
If leaking is in contact with skin or gets in eyes/mouth, rinse immediately and seek emergen-
cy treatment immediately. Please clean the baery compartment thoroughly prior to
installing new baery.
4.Never use the remote control in condions below:
– Places with high humidity, e.g. a bathroom
– Places with high temperature, e.g. near a heater or stove
– Places with extremely low temperature
– In dusty places
5.Remove the baery when unused for a long period of me to avoid baery leakage.
6.Do not use this product when baery compartment is not securely closed, and keep the
remote control away from children.
7.There is a cell baery inside this product, if swallowed it will cause serious bodily injury;
possibly death in 2 hours. Never let children touch the baery.
8.If the baery is accidentally swallowed, rush to hospital immediately.
* Connect the power cable included to power input port on the rear panel, and then insert
power plug into the mains socket on the ground or on the wall.
* Refer to the "Power switch" on page 6 to turn on/off the speaker, and press the " "
buon on the remote control to switch to Standby/Power on state.
(Note: Turning off the power switch will only turn the amplifier off, and power source is sll
available. To thoroughly turn the speaker off, please unplug the power cable from the mains
socket.)
* Place the speaker on a solid, leveled and steady surface.
* The speaker with compact and delicate look can be easily carried around. It can also be
placed on desktop, in bedroom, in living room, or at any other indoor corners. Make your
room full of vitality.
1.Line in input: Insert the RCA audio cable included into the "LINE IN" port on the speaker; then connect
the RCA audio cable to your playback device.
Note:
* Pin code for connecon is "0000" if needed.
* For inial pairing, the blue light will flash, and will be steady lit aer pairing is successful. If
the blue light flashes in a breathing paern, it means the pairing failed, please pair again.
Operaons may be different among different devices, please refer to the operaonal instruc-
ons aached with the devices.
* Effecve Bluetooth connecon distance is within 10 meters.
* The Bluetooth of P100X can only be searched and connected in Bluetooth input. The exisng
Bluetooth connecon will be disconnected once the speaker is switched to line in input. When
switched to Bluetooth input, the speaker will try to connect to the Bluetooth device connected
last me.
* To disconnect Bluetooth, press and hold the " " buon on the remote control for over 2
seconds, or press and hold the "VOLUME/INPUT" dial on the front panel of the speaker.
* To enjoy all Bluetooth funcons please ensure your audio device has A2DP(Advanced Audio
Distribuon Profile) and AVRCP(Audio Video Remote Control Profile) profiles.
* When connected to this product, Bluetooth connecvity and funcons may be different
among different Bluetooth devices, depending on soware sengs of Bluetooth devices.